| Section 1 Identification |
| Product Number: | C1972 |
| Health: | 2 |
| Flammability | 0 |
| Reactivity | 0 |
Hazard Rating:
| Least | Slight | Moderate | High | Extreme |
| 0 | 1 | 2 | 3 | 4 |
NA = Not Applicable NE = Not Established
|
|
| Product Name: | Lead Acetate 5% w/v Solution |
| Trade/Chemical Synonyms | |
| Formula: | N/A |
| RTECS: | |
| C.A.S | See Below |
| Section 2 Component Mixture |
| Sara 313 | Component | CAS Number | % | Dim | Exposure Limits: |
|
Water, Deionized ASTM Type II | CAS# 7732-18-5 | Balance | V/V | None Established |
|
Acetic Acid, Glacial | CAS# 64-19-7 | 0.2% | V/V | 10 ppm OSHA TWA, 15 ppm OSHA STEL |
|
Lead Acetate | CAS# 6080-56-4 | 5% | W/V | ACGIH TLV 0.05 mg(Pb)/mƒ (dust) |
|
| Section 3 Hazard Identification (Also
see section 11) |
| May be harmful if swallowed. May cause irritation. Avoid breathing vapors, or dusts. Use with adequate ventilation. Avoid contact with eyes, skin, and clothes. Wash thoroughly after handling. |
| Section 4 First Aid Measures |
May be harmful if swallowed. May cause irritation. Avoid breathing vapors, or dusts. Use with adequate ventilation. Avoid contact with eyes, skin, and clothes. Wash thoroughly after handling.
FIRST AID: SKIN: Remove contaminated clothing. Wash exposed area with soap and water. if irritation persists, seek medical attention.
EYES: Wash eyes with plenty of water for at least 15 minutes, lifting lids occasionally. Seek Medical Aid. INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen
INGESTION: If swallowed, induce vomiting immediately after giving two glasses of water. Never give anything by mouth to an unconscious person.
|
| Section 5 Fire Fighting Measures |
| Fire Extinguisher Type: | Any means suitable for extinguishing surrounding fire |
| Fire/Explosion Hazards: | Closed containers exposed to heat may explode |
| Fire Fighting Procedure: | Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and clothing. |
|
|
| Section 6 Accidental Release
Measures |
Absorb spill with inert material, then place in a chemical waste container. Dispose of in a manner consistent with federal, local law.
|
| Section 7 Handling and
Storage |
| Store in secure poison area. Keep container tightly closed |
| Section 8 Exposure Controls
& Personal Protection |
Respiratory Protection:NIOSH/MSHA-approved respirator
Other Protective Equipment:
Wear appropriate clothing to prevent skin exposure
|
| Section 9 Physical and Chemical Properties |
| Melting Point: | Information not available | Specific Gravity | ~1.05
|
| Boiling Point: | Information not available |
Percent Volatile by Volume: | Information not available |
| Vapor Pressure: | Information not available |
Evaporation Rate: | Information not available |
| Vapor Density: |
Information not available |
Evaporation Standard: |
|
| Solubility in Water: |
Soluble |
Auto ignition Temperature: |
Information not available |
| Appearance and Odor: |
Clear, colorless, odorless liquid |
Lower Flamm. Limit in Air: |
Not applicable |
| Flash Point: |
Information not available |
Upper Flamm. Limit in Air: |
Not applicable |
|
| Section 10 Stability and Reactivity Information |
| Stability: Stable | Conditions to Avoid: Avoid contact with incompatible materials. |
Materials to Avoid:
Acids and bases |
Hazardous Decomposition Products:
Not known to occur |
| Hazardous Polymerization:Will Not Occur |
| Condition to Avoid:None known |
|
| Section 11
Additional Information |
| Ingestion may be fatal. May cause nausea, vomiting, headache, dizziness, gastrointestinal irritation. Inhalation may cause tightness and pain in chest, coughing, and difficulty in breathing. Contact with skin or eyes may cause irritation. Conditions aggravated/target organs: Persons with pre-existing eye, skin or respiratory conditions may be more susceptible. |
| DOT Classification: Lead Acetate solution, 6.1, UN1616, PG III |
DOT regulations may change from time to time. Please
consult the most recent version of the relevant regulations.
| Revision No:0 | Date Entered: 9/1/2006 |
Approved by: WPF |
|
|
|