| Section 1 Identification |
| Product Number: | C1990 |
| Health: | 1 |
| Flammability | 1 |
| Reactivity | 0 |
Hazard Rating:
| Least | Slight | Moderate | High | Extreme |
| 0 | 1 | 2 | 3 | 4 |
NA = Not Applicable NE = Not Established
|
|
| Product Name: | Linseed Oil, Raw |
| Trade/Chemical Synonyms | |
| Formula: | N/A |
| RTECS: | OI9690000 |
| C.A.S | CAS# 8001-26-1 |
| Section 2 Component Mixture |
| Sara 313 | Component | CAS Number | % | Dim | Exposure Limits: |
|
Linseed Oil, Raw | CAS# 8001-26-1 | 100 % | W/W | TLV 10 mg/mƒ (oilmist) |
|
| Section 3 Hazard Identification (Also
see section 11) |
| Generally not hazardous in normal handling, however good laboratory practices should always be used. Avoid long term exposure to skin or by inhalation. |
| Section 4 First Aid Measures |
Generally not hazardous in normal handling, however good laboratory practices should always be used. Avoid long term exposure to skin or by inhalation.
FIRST AID: SKIN: Wash exposed area with soap and water. If irritation persists, seek medical attention.
EYES: Wash eyes with plenty of water for at least 15 minutes, lifting lids occasionally. Seek Medical Aid. INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen
INGESTION: Give several glasses of milk or water. Vomiting may occur spontaneously, but it is not necessary to induce. Never give anything by mouth to an unconscious person.
|
| Section 5 Fire Fighting Measures |
| Fire Extinguisher Type: | Water spray, Carbon dioxide, dry chemical, foam. |
| Fire/Explosion Hazards: | None Known. |
| Fire Fighting Procedure: | Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and clothing. |
|
|
| Section 6 Accidental Release
Measures |
Collect on absorbent and add water
|
| Section 7 Handling and
Storage |
| To be performed in compliance with all local, state, and federal regulations |
| Section 8 Exposure Controls
& Personal Protection |
Respiratory Protection:l5125
Other Protective Equipment:
Wear appropriate clothing to prevent skin exposure
|
| Section 9 Physical and Chemical Properties |
| Melting Point: | -19 Deg C | Specific Gravity | 0.93
|
| Boiling Point: | >340 Deg C |
Percent Volatile by Volume: | 0 |
| Vapor Pressure: | Information not available |
Evaporation Rate: | 0 |
| Vapor Density: |
Information not available |
Evaporation Standard: |
|
| Solubility in Water: |
Not soluble |
Auto ignition Temperature: |
Not applicable |
| Appearance and Odor: |
Yellow to amber oil, characteristic odor |
Lower Flamm. Limit in Air: |
Not applicable |
| Flash Point: |
432 Deg F |
Upper Flamm. Limit in Air: |
Not applicable |
|
| Section 10 Stability and Reactivity Information |
| Stability: Stable | Conditions to Avoid: Auto oxidation can lead to spontaneous combustion. Do not allow to be absorbed and stored on rags, towels, etc. |
Materials to Avoid:
Chlorine |
Hazardous Decomposition Products:
CO, Acrolein |
| Hazardous Polymerization:Will Not Occur |
| Condition to Avoid:None known |
|
| Section 11
Additional Information |
| Can cause irritation to skin and eyes. If comes in contact with skin wash with soap and water. If comes in contact with eyes flush with water. If inhaled move to fresh air. If ingested get medical assistance as with all these occurences should be done. Target organs: None. Persons with pre-existing disorders may be more susceptible. |
| DOT Classification: Not Regulated |
DOT regulations may change from time to time. Please
consult the most recent version of the relevant regulations.
| Revision No:0 | Date Entered: 9/1/2006 |
Approved by: WPF |
|
|
|