Material Safety Data Sheet
Science Stuff, Inc.
1104 Newport Ave
Austin, TX 78753
Phone (512) 837-6020
Chemtrec 800-424-9300
24 Hour Emergency Assistance
Section 1 Identification
Product Number:C2010 
Health:
Flammability
Reactivity
Hazard Rating:
LeastSlightModerateHighExtreme
01234
NA = Not Applicable NE = Not Established
Product Name:Magnesium Standard 1.0 ppm 
Trade/Chemical Synonyms 
Formula:N/A
RTECS:None 
C.A.SSee Below
Section 2 Component Mixture
Sara 313ComponentCAS Number%DimExposure Limits:
Water, Deionized ASTM Type II CAS# 7732-18-5 Balance V/V None Established 
Magnesium  CAS# 7439-95-4 <0.01% W/V None established 
Nitric Acid  CAS# 7697-37-2 3.5% V/V OSHA TWA 2 ppm (5mg/mƒ), STEL 4 ppm (10mg/mƒ) 
Section 3 Hazard Identification (Also see section 11)
Generally not hazardous in normal handling, however good laboratory practices should always be used. Avoid long term exposure to skin or by inhalation. 
Section 4 First Aid Measures
Generally not hazardous in normal handling, however good laboratory practices should always be used. Avoid long term exposure to skin or by inhalation.

FIRST AID: SKIN: Wash exposed area with soap and water. If irritation persists, seek medical attention.

EYES: Wash eyes with plenty of water for at least 15 minutes, lifting lids occasionally. Seek Medical Aid. INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen

Give several glasses of water. Vomiting may occur, but it is not necessary to induce.
Section 5 Fire Fighting Measures
Fire Extinguisher Type:Any means suitable for extinguishing surrounding fire
Fire/Explosion Hazards:None
Fire Fighting Procedure:Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and clothing.
Section 6 Accidental Release Measures
Absorb spill with inert material, then place in a chemical waste container. Neutralize with a weak base.
Section 7 Handling and Storage
Store in a cool, dry, well-ventilated place away from incompatible materials. Wash thoroughly after handling. 
Section 8 Exposure Controls & Personal Protection
Respiratory Protection:None required
Ventilation: Mechanical: Hand Protection:NIOSH Approved Gloves
Local Exhaust: Eye Protection:Splash Goggles
Other Protective Equipment: Wear appropriate clothing to prevent skin exposure
Section 9 Physical and Chemical Properties
Melting Point:<5°CSpecific GravityInformation not available
Boiling Point:>95°C Percent Volatile by Volume:>95%
Vapor Pressure:Information not available Evaporation Rate:Information not available
Vapor Density: Information not available Evaporation Standard:
Solubility in Water: Soluble Auto ignition Temperature: Not applicable
Appearance and Odor: Clear odorless liquid Lower Flamm. Limit in Air: Not applicable
Flash Point: Not applicable Upper Flamm. Limit in Air: Not applicable
Section 10 Stability and Reactivity Information
Stability: StableConditions to Avoid: Avoid contact with incompatible materials.
Materials to Avoid:
Hazardous Decomposition Products:
Toxic fumes: Nitric oxides may be released in fire
Hazardous Polymerization:Will Not Occur
Condition to Avoid:None known
Section 11 Additional Information
Conditions aggravated/target organs: Corrosive! Persons with pre-existing skin, eye and respiratory conditions will be more susceptible. Acute: Irritation or burns to skin, eyes and respiratory tract. Chronic: Dermatitis, eye damage. 
DOT Classification: Not Regulated
DOT regulations may change from time to time. Please consult the most recent version of the relevant regulations.
Revision No:0Date Entered: 9/1/2006 Approved by: WPF

The information contained herein is believed to be accurate and is offered in good faith for the user's consideration and investigation. No warranty is expressed or implied regarding the completeness or accuracy of this information, whether originating from Science Stuff, Inc. or from an alternate source. Users of this material should satisfy themselves by independent investigation of current scientific and medical information that this material may be safely handled.