| Section 1 Identification |
| Product Number: | C3002 |
| Health: | 1 |
| Flammability | 0 |
| Reactivity | 0 |
Hazard Rating:
| Least | Slight | Moderate | High | Extreme |
| 0 | 1 | 2 | 3 | 4 |
NA = Not Applicable NE = Not Established
|
|
| Product Name: | Zinc Sulfate 0.05 Molar Solution |
| Trade/Chemical Synonyms | |
| Formula: | N/A |
| RTECS: | None |
| C.A.S | See Below |
| Section 2 Component Mixture |
| Sara 313 | Component | CAS Number | % | Dim | Exposure Limits: |
|
Water, Deionized ASTM Type II | CAS# 7732-18-5 | Balance | V/V | None Established |
|
Zinc Sulfate Heptahydrate | CAS# 7446-20-0 | ~1.5% | W/V | OSHA TWA 10 mg/mƒ |
|
| Section 3 Hazard Identification (Also
see section 11) |
| Generally not hazardous in normal handling, however good laboratory practices should always be used. Avoid long term exposure to skin or by inhalation. |
| Section 4 First Aid Measures |
Generally not hazardous in normal handling, however good laboratory practices should always be used. Avoid long term exposure to skin or by inhalation.
FIRST AID: SKIN: Wash exposed area with soap and water. If irritation persists, seek medical attention.
EYES: Wash eyes with plenty of water for at least 15 minutes, lifting lids occasionally. Seek Medical Aid. INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen
INGESTION: If swallowed, induce vomiting immediately after giving two glasses of water. Never give anything by mouth to an unconscious person.
|
| Section 5 Fire Fighting Measures |
| Fire Extinguisher Type: | Any means suitable for extinguishing surrounding fire |
| Fire/Explosion Hazards: | None |
| Fire Fighting Procedure: | Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and clothing. |
|
|
| Section 6 Accidental Release
Measures |
Absorb spill with inert material. Flush excess down drain.
|
| Section 7 Handling and
Storage |
| Store in a cool dry place. Do not get in eyes, on skin, on clothing. Wash thoroughly after handling. |
| Section 8 Exposure Controls
& Personal Protection |
Respiratory Protection:None required
Other Protective Equipment:
Use safe laboratory handling procedures.
|
| Section 9 Physical and Chemical Properties |
| Melting Point: | >2 Deg C | Specific Gravity | 1
|
| Boiling Point: | 100 Deg C |
Percent Volatile by Volume: | >98% |
| Vapor Pressure: | not available |
Evaporation Rate: | Information not available |
| Vapor Density: |
not available |
Evaporation Standard: |
|
| Solubility in Water: |
Soluble |
Auto ignition Temperature: |
Not applicable |
| Appearance and Odor: |
Colorless odorless liquid |
Lower Flamm. Limit in Air: |
Not applicable |
| Flash Point: |
Not flammable |
Upper Flamm. Limit in Air: |
Not applicable |
|
| Section 10 Stability and Reactivity Information |
| Stability: Stable | Conditions to Avoid: None known |
Materials to Avoid:
Concentrated Acids and Bases, Water reactive materials. |
Hazardous Decomposition Products:
Not known to occur |
| Hazardous Polymerization:Will Not Occur |
| Condition to Avoid:None known |
|
| Section 11
Additional Information |
| Conditions aggravated / target organs: None |
| DOT Classification: Not Regulated |
DOT regulations may change from time to time. Please
consult the most recent version of the relevant regulations.
| Revision No:0 | Date Entered: 9/1/2006 |
Approved by: WPF |
|
|
|